H3 LED lamp set 12/24 Volt white

H3 LED lamp set, suitable for 12 & 24 volt use.

Are you looking for an H3 LED lamp that you can replace for an originally mounted halogen lamp? Then this H3 LED lamp might be the lamp you’re looking for. The LED lamp features 2 LED’s and is supplied per set of 2 pieces. The LED lamp has a light output that you can compare with a 60w halogen lamp. The H3 LED lamp white can be used on both 12 and 24 volt. This means that you can use your H3 LED lamp for example in your car, motorcycle, truck, camper or other type of vehicle. To make sure that the white LED lamp fits, the originally mounted lamp should be the same as the one in image 3. If this does not match, then the LED lamp will not fit.

To make sure that the H3 type 2 LED lamp white is suitable for your vehicle or trailer, we have listed a number of specifications below. All this to make clear why this might be the H3 LED lamp you’re looking for. The LED lamp features the ECE R10 certification mark among others. This certification mark means that the lamp will not cause interference during activation, for example on the radio signal. The LED lamp can also be used up to 30 volt. This means that the LED lamp is protected against voltage spikes that can occur during vehicle startup.

Light output:

The H3 type 2 LED lamp features 2 hi-power LED’s. The 2 LED’s provide a light output of 2000 lumen per lamp. A mounted set delivers no less than 4000 lumen. This is enough to properly illuminate the road ahead of you. An H3 lamp is often found in the fog light or dipped beam section of your car, motorcycle, truck or other type of vehicle. But you can also find the lamp in the high beam section.

Please note that these LED lamps are in most cases CAN-Bus proof. This means that the lamp will not give a notification on the dashboard. This mainly applies to older models of cars and trucks. Newer vehicles may in some cases receive a notification on the dashboard. Extra lighting such as spotlights or skylights are excluded from this system.

Why this LED lamp doesn’t have E-mark:

Replacement lights must comply with European standards for safety, water resistance, and short circuit prevention (ECE R37). These standards are based on old incandescent and halogen lights. LED replacement lights cannot comply with this because they don’t have a filament. As a result, this LED light doesn’t receive the ECE R37 certification and officially cannot be used on public roads. You can safely use this BA15S LED light on your own property or, for example, in racing. This way, you get the most out of the light without causing legal issues.