BA15S LED bulb red 10/30V – 2 pieces

BA15S LED bulb red with 9-smd, for 12/24V use.

Are you looking for a good LED bulb that you can exchange for your original BA15S halogen bulb? Then this red BA15S LED bulb might be exactly what you are looking for. The bulb has 9 LEDs that shine all around and is delivered per set of 2 pieces. Thanks to the 9 LEDs, you get a light output comparable to a 21W halogen bulb. The BA15S LED bulb red works on 12/24V, which means that you can use it, for example, in your car, truck, camper or trailer. Please note: to fit, the original bulb must be the same as in picture 4. If this does not match, the LED bulb will not fit.

To be sure that the BA15S LED bulb red is suitable for your vehicle or trailer, we have listed the most important specifications for you below. This way you can immediately see why this might be the BA15S LED bulb you are looking for. The bulb has the ECE R10 mark, which means that it does not cause interference on, for example, your radio signal. In addition, the LED bulb can be used up to 32 volts, making it protected against peak voltage during starting your vehicle.

Dimensions:

To be sure that you can mount the BA15S LED bulb red where you want, we have noted the dimensions below. The dimensions of this red LED bulb with bayonet connection are as follows:

• Length: 39 mm
• Width top: 20 mm
• Width bottom: 15 mm

Note, these LED lamps are not CAN-Bus proof. This means that this lamp may trigger a defective lamp warning on your dashboard. This mainly applies to newer car models, trucks are often excluded from this. Additional lamps such as spotlights or skylights are also excluded from the CAN-Bus system.

Other colors:

Are you looking for a r10w or p21w LED bulb, but the BA15S LED bulb red is not the color you are looking for? This LED bulb with bayonet connection is also available in the following colors:

• BA15S LED bulb amber yellow – 9 smd
• BA15S LED bulb xenon white – 9 smd
• BA15S LED bulb warm white – 9 smd

Why does this BA15S LED bulb not have an E-Mark:

Replacement bulbs must comply with European standards for safety, water resistance and prevention of short circuits (ECE R37). These standards are based on the old incandescent and halogen bulbs. LED replacement bulbs cannot meet these requirements because they do not have a filament. As a result, this LED bulb does not receive the ECE R37 mark and is officially not allowed to be used on public roads. You can safely use this BA15S LED bulb on your own property or, for example, in racing. This way you get the most out of the bulb without causing legal problems.