Loop LED strip RGB 10mm 5050

Loop LED strip RGB 10mm, suitable for an RGB LED strip with 5050 LED’s.

Are you looking for a handy connector to run your RGB LED strip neatly and smoothly around a corner? Then this 12/24 volt connector is exactly what you need. With this connecting piece, you can easily install your LED strip in a corner, for example, without having to force the strip or bend it sharply. This prevents damage, cable breaks and defective LED’s. Problems that often occur when an LED strip is placed too tightly in a corner.

Easy to install

The connector features a sturdy plastic click system, making installation very easy. You don’t need special tools; just scissors to cut the strip at the cutting point. For LED strips with a silicone protective layer (IP65), first remove a small piece of silicone to expose the contacts. For strips without coating (IP33), you can attach the connector directly.

Make sure you only cut the LED strip at the indicated cutting points. On our RGB strips, these are marked with a scissors symbol. Cut the strip at the indicated spot, click the strip parts into the connector and your LED strip is immediately ready for use again.

Other available options

Looking for a connector for a different application? Also check out:

• Loop 10mm LED strip
• Connector 10mm LED strip
• Loop 8mm LED strip
• Connector 8mm LED strip

Note: not suitable for single-color strips

This connector is only suitable for RGB LED strips of 10 mm wide with the familiar 4-pin system. If you have a solid color LED strip of the 5050 type, this connector will not fit.