BA15S LED light 24 volt red – 2 pieces

BA15S LED light red with 8-smd, suitable for 24 volt use.

Are you looking for a good LED light that you can swap for your original BA15S halogen light? Then this red BA15S LED light might be exactly what you’re looking for. The light has 8 LED’s and comes in a set of 2 pieces. Thanks to the 8 LED’s, you can be sure that the light shines all around. The light output is comparable to a 10W halogen light. The BA15S LED light red only works on 24 volts, making it ideal for your truck, camper, or trailer, for example. Note: the original light must be the same as shown in image 3. If this doesn’t match, the LED light won’t fit.

To make sure that the BA15S LED light red is suitable for your vehicle or trailer, we’ve listed the main specifications for you below. This way, you can immediately see why this might be the LED light you’re looking for. The light has the ECE R10 certification, which means it doesn’t cause interference with, for example, your radio signal. Additionally, the LED light can be used up to 30 volts, protecting it against voltage spikes that can occur when starting your vehicle. In short: a perfect BA15S 24V LED light red that you can use, for example, as interior lighting for your truck or trailer.

Dimensions:

To ensure you can mount the BA15S LED light red where you want, we’ve noted the dimensions below. The dimensions of this red LED light with bayonet connection are as follows:

• Length: 35 mm
• Top width: 16 mm
• Width bottom: 15 mm

Note, these LED lamps are not CAN-Bus proof. This means that this lamp may trigger a defective lamp warning on your dashboard. This mainly applies to newer car models, trucks are often excluded from this. Additional lamps such as spotlights or skylights are also excluded from the CAN-Bus system.

Other colors:

Are you looking for an r5w or r10w LED light, but the BA15S LED light red for 24 volt use isn’t the color you’re looking for? Know that the LED light with bayonet connection is also available in the following colors:

• BA15S 24 volt – warm white 3000k
• BA15S 24 volt – yellow
• BA15S 24 volt – white 5700k
• BA15S 24 volt – blue
  
• BA15S 24 volt – green
  

Why this BA15S LED light doesn’t have an E-Mark:

Replacement lights must comply with European standards for safety, water resistance, and short circuit prevention (ECE R37). These standards are based on old incandescent and halogen lights. LED replacement lights cannot comply with this because they don’t have a filament. As a result, this LED light doesn’t receive the ECE R37 certification and officially cannot be used on public roads. You can safely use this BA15S LED light on your own property or, for example, in racing. This way, you get the most out of the light without causing legal issues.