DRL unit Iveco 2020+ warm white

DRL unit WARM WHITE, suitable for an Iveco S-Way with year of construction 2020+.

Want to replace the daytime running lights on your Iveco S-Way with warm white? Then this DRL set might be just what you're looking for. It consists of four LED plates, allowing you to replace both the left and right modules. You can easily replace the original lights with the orange version. You'll find the steps to follow at the bottom of the page.

Because you want to be sure the set is suitable for your truck before purchasing, we've listed a few important points here. It's important that the original units are exactly the same as those shown in image two. If the original unit doesn't match, this replacement bulb won't fit. Furthermore, the Iveco S-Way warm white daytime running lights are only suitable for models manufactured in 2020 or later. This DRL unit is roadworthy, but during the vehicle inspection (MOT), the garage may request that you replace the original module. Therefore, keep this in a safe place to avoid problems during the inspection.

Other models: 

Do you own an Iveco truck, but it's not equipped with the same units shown in image 2? Or do you simply want a different color? Then take a look at the other available DRL unit models for the Iveco truck below: 

• S-Way 2020+ ORANGE

Installation:

To install the Iveco S-Way warm white daytime running lights, follow these steps. Installing the orange DRL unit will take approximately one hour per headlight. Figures 3 and 4 show a computer-generated example of how the set will ultimately light up after installation.

1. Remove the connector from the existing lighting.
2. Remove the screws securing the original diode holders.
3. Remove the diode holders from the cooling plates.
4. Remove the thermal paste and clean the surface well.
5. Bring the supplied thermal paste in a thin even layer to the cooling plates where the lamp will be mounted.
6. Push the diode holder into the thermal paste and secure it carefully with the original screw.
7. Insert the connector into the new diode holder.
8. The daytime running lights of your Iveco S-Way are ready for use.

Don't just want to replace the warm white daytime running lights on your Iveco S-Way? Are you looking for more LED lighting that you can install in or around your Iveco truck? Then take a look at the page Iveco lighting.