T10 LED red 24 volt - 2 pieces
Beschikbaarheid: In stock
| ordered before 15:00, shipped today |
€7,60 Excl. VAT €9,20 incl. 21% VAT
T10 LED lamp red, for 24 volt use.
Are you looking for a good LED lamp that you can exchange for your original mounted T10 halogen lamp? Then this red T10 LED lamp may be the lamp you are looking for. The LED lamp is equipped with 4 LED's and is supplied per set of 2 pieces. The LED lamp has a light output that you can compare with a 5 watt halogen lamp. The T10 LED lamp red is only suitable for 24 volt use. This means that you can use the LED lamp for example in your truck or trailer. To ensure that the red LED lamp fits, the originally fitted lamp must be the same as that shown in picture 3. If this does not match, the lamp will not fit.
To ensure that the T10 LED lamp red 24 volt is suitable for your vehicle or trailer, we have written out a number of specifications below. All this to make it clear to you why this might be the T10 LED lamp you are looking for. This LED lamp is, among other things, provided with the ECE R10 quality mark. This quality mark means that the lamp will not cause any interference during activation, for example on your radio signal. The LED lamp can also be used up to 32 volts, which means that the LED lamp is protected against peak voltage that can arise while starting your vehicle. The T10 LED lamp red 24 volts can be used as interior lighting for your truck or trailer, for example.
Installation of the T10 LED lamp:
To install the T10 LED bulb red 24 volt in your vehicle, you must follow the following steps:
- Switch off the lighting of your vehicle.
- Remove the old halogen lamp from the holder.
- Place the T10 LED lamp in the holder.
- Turn on your vehicle's lights and check if the LED bulb works. If the lamp does not work, turn the lamp a quarter turn.
- The lighting is now ready for use.
Please note, these LED lamps are not CAN-Bus proof. This means that this lamp can report a defective lamp on your dashboard. This mainly applies to newer models of cars, trucks are often excluded. Additional lamps such as spotlights or skylights are also excluded from the CAN-Bus system.
Are you looking for a w5w LED lamp, but is the T10 LED lamp red for 24 volt truck not the color you are looking for? Then know that the T10 LED lamp with 4 LEDs is also available in the following colours:
- T10 LED lamp orange 24 volt
- T10 LED lamp blue 24 volt
- T10 LED lamp green 24 volt
- T10 LED lamp white 24 volt
Why does this T10 LED lamp not have an E-mark:
Replacement lamps must comply with European standards for safety, watertightness and short-circuit prevention (ECE-R37). These standards are based on the incandescent and halogen lamp of the past. LED replacement lamps cannot meet those standards. The reason is because there is no filament in it. As a result, this LED lamp does not receive the ECE R37 quality mark and may therefore not be used officially on public roads. You may use this T10 LED lamp red 24 volt on, for example, your own terrain or in racing.
|Type of lighting||
|Number of LED's||
Er zijn nog geen beoordelingen.