DRL unit MAN 2020+ warm white

DRL unit WARM WHITE, suitable for a MAN TG3.

Want to replace the original white LED daytime running lights in your MAN TG3 with warm white? Then this DRL set might be just what you're looking for. It includes two LED plates, allowing you to replace both the left and right modules. You can easily replace the original lights with the warm white version. You'll find the steps to follow at the bottom of the page.

Because you want to be sure the set is suitable for your truck before purchasing, we've listed a few important points here. It's important that the original units are exactly the same as those shown in image two. If the original unit doesn't match, this replacement bulb won't fit. Furthermore, the MAN TG3 warm white daytime running light is only suitable for models manufactured from 2020 onwards. This DRL unit is roadworthy, but during the vehicle inspection (APK), the garage may request that the original module be replaced. Therefore, keep this in a safe place to avoid problems during the inspection.

Other models: 

Do you own a MAN TGS, TGA, or TGX truck, but don't want to change the daytime running lights to warm white? Or do the units not match those shown in the photo? Then know that this DRL module is also available in other colors and models. View the other options below:

• MAN TG1 LED DRL orange 2012+
• MAN TG2 LED DRL orange 2021+
  
• MAN TG3 LED DRL orange 2021+

Installation:

To install the MAN TG3 daytime running lights, follow these steps. Installing the warm white DRL unit will take approximately half an hour to one hour per headlight. Image 3 shows an example of how the set will ultimately light up after installation.

1. Remove the connector from the existing lighting.
2. Remove the screws securing the original diode holders.
3. Remove the diode holders from the cooling plates.
4. Remove the thermal paste and clean the surface well.
5. Bring the supplied thermal paste in a thin even layer to the cooling plates where the lamp will be mounted.
6. Push the diode holder into the thermal paste and secure it carefully with the original screw.
7. Insert the connector into the new diode holder.
8. The lighting of your MAN TG3 is ready for use.

Don't just want to replace the warm white daytime running lights on your MAN TG3? Are you looking for more LED lighting that you can install in or around your MAN truck? Then take a look at the page MAN lighting.