Are you looking for an H3 LED lamp that you can exchange for your original mounted halogen lamp? Then this H3 LED lamp may be the lamp you are looking for. The LED lamp is equipped with 2 LED's and is supplied per set of 2 pieces. The LED lamp has a light output that you can compare with a 60w halogen lamp. The H3 LED lamp white can be used on both 12 and 24 volts. This means that you can use H3 LED lamp for example in your car, motorcycle, truck, camper or other type of vehicle. To ensure that the white LED lamp fits, the original fitted lamp must be the same as that shown in picture 3. If this does not match, the LED lamp will not fit.
To make sure that the H3 type 2 LED lamp white is suitable for your vehicle or trailer, we have written a number of specifications below. All this to make it clear to you why this may be the H3 LED lamp you are looking for. The LED lamp has, among other things, the ECE R10 quality mark. This quality mark means that the lamp will not cause any interference during activation, for example on your radio signal. The LED lamp can also be used up to 30 volts. This means that the LED lamp is protected against peak voltage that can occur when starting your vehicle.
Light output:
The H3 type 2 LED lamp is equipped with 2 hi-power LED's. The 2 LEDs provide a light output of 2000 lumens per lamp. A mounted set provides no less than 4000 lumens. This is enough to light the way for you well. An H3 lamp can often be found in the fog light or low beam part of your car, motorcycle, truck or other type of vehicle. But you can also find the lamp in the high beam section.
Please note, these LED lamps are CAN-Bus proof in most cases. This means that the lamp will not give a message on your dashboard. This mainly applies to somewhat older models of cars and trucks. Newer vehicles can in some cases receive a message on the dashboard. Additional lighting such as spotlights or skylights are excluded from this system.
Other versions:
Do you want to purchase a LED lamp? But is the H3 type 2 version not the lamp you are looking for? Then know that the LED replacement lamp is also available in the following versions:
Replacement headlamps must comply with European standards regarding safety, watertightness and the prevention of short circuits (ECE-R37). These standards are based on the incandescent and halogen lamps of the past. LED replacement headlamps cannot meet those standards because there is no filament in them. That is why they do not receive the E-mark R37 and they are therefore officially not allowed to be used on public roads. Drivers can be fined by the police during a check, despite the fact that the light image of the lamp does pass the MOT. You should be allowed to use the H3 LED lamps on your own terrain or in racing, for example.
Beoordelingen
Er zijn nog geen beoordelingen.