BA15S LED light 9/32V white – 2 pieces

BA15S LED light white with 8-smd, for 12 & 24 volt.

Are you looking for an LED light that you can swap for your original BA15S halogen light? Then this Nedking BA15S LED light white might be exactly what you’re looking for. The light has 8 LEDs and comes in a set of 2 pieces. Thanks to the 8 LEDs, the light shines all around and replaces a 21 watt halogen light. The Nedking BA15S LED light works on 12 and 24 volts. This means you can use it in your car, truck, camper or trailer, for example. Note: the original light must be the same as in image 2. If this doesn’t match, the LED light won’t fit.

To make sure the Nedking BA15S LED light white is suitable for your vehicle, we’ve listed the main specifications below. The light has the ECE R10 certification, which means it doesn’t cause interference with, for example, your radio signal. Moreover, the LED light can handle up to 32 volts, protecting it against voltage spikes that can occur when starting your vehicle.

Dimensions:

To ensure you can easily install the BA15S LED light white, we’ve listed the dimensions for you below. The dimensions of this white LED light with bayonet connection are as follows:

• Length: 40 mm
• Top width: 23 mm
• Width bottom: 15 mm

Note, these LED bulbs are not CAN-Bus proof. This means that this bulb can trigger a defective bulb warning on your dashboard. This mainly applies to newer car models, trucks are often excluded from this. Also, additional lights such as spotlights or skylights are excluded from the CAN-Bus system.

Other colors:

Are you looking for an R10W or P21W LED light, but the BA15S LED light white isn’t the color you’re looking for? No worries! This LED light with bayonet connection is also available in the following colors:

• BA15S LED light orange – 8 smd
• BA15S LED light red – 8 smd

Why this BA15S LED light doesn’t have an E-Mark:

Replacement lights must comply with European standards for safety, water resistance, and short circuit prevention (ECE R37). These standards are based on old incandescent and halogen lights. LED replacement lights cannot comply with this because they don’t have a filament. As a result, this LED light doesn’t receive the ECE R37 certification and officially cannot be used on public roads. You can safely use this BA15S LED light on your own property or, for example, in racing. This way, you get the most out of the light without causing legal issues.